50
Profile
Installation Manual
PROFILE INSTALLATION MANUAL
Eaton.com/profile
P a g e
|
48
Eaton’s Profile Command Console
Installation Manual
Step 8. Install The Rear Work Surface
The following figure shows the installation a PEC60602 rear work
surface. Work surfaces for other corner sit-to-stand desk
models attach the same way. In order to minimize handling weight, some larger 72” x 72” desks have 2-piece rear work
surfaces, with a seam along the center of the surface.
Position the rear work-surface panel(s) on top of the rear work surface support frame, aligning its mounting holes with the
holes in the frame. When properly positioned, the rear edges of the work surface will be about 2-1/4” from the core wall
frames. Attach the work surface with #10 x ¾” Phillips head wood screws. SOME SCREW HOLES MAY NOT BE ACCESSABLE
UNTIL THE DESK IS WIRED AND ELEVATED. IF SO, INSTALL THESE SCREWS LATER IN THE ASSEMBLY. DO NOT OMIT ANY
SCREWS.
Step 9a. Install The Front Work Surface Support Brackets
This step only applies to corner sit-to-stand desks with motorized
front work surfaces (refer to column 5 in table 53). If your desk
has a manually counterbalanced front work surface, refer to step 11 to learn how to install the counterbalance mechanism.
NOTE: PL4842482 model corner sit-to-stand desks require a
unique front work surface support component. Refer to step 9b
for this model desk.
The support brackets have several beveled mounting holes. Use the table below to determine which holes to use for your
corner sit-to-stand desk model. Position the work surface support brackets on top of the lift motors, aligning the correct holes
with the lift motors. Attach each bracket to the lift motor with (4) M6 x 14mm Allen flat head machine screws. See figure 76.
WARNING: DO NOT PINCH OR DAMAGE THE LIFT MOTOR WIRES OR CONNECTORS.
Figure 75
2-1/4”
(typ.)
Figure 76
(This example uses holes 1 and 4 for desk
PEC60602)
M6 x 14mm Allen
flat head machine
screws
Fro
nt
Re
ar
1
3
4
2
5
6
7
8
NOTICE
NOTICE
NOTICE