INSTALLATION
Eaton 9140 UPS (7.5–10 kVA) User's Guide
S
164201622 Rev 3
www.eaton.com/powerquality
30
Installing the EBM Batteries
To install the battery trays into the EBM cabinet:
1.
Verify that the battery circuit breaker on the EBM rear panel is in
the OFF (O) position (see Figure 26 on page 44).
2.
Remove the EBM front cover (see Figure 11).
To remove the front cover, loosen the two front cover screws.
Grasp the fingergrips on both sides of the cover and pull the cover
forward firmly.
Figure 11. Removing the EBM Front Cover
3.
Slide the battery trays into the cabinet (see Figure 12). Push each
tray in until the battery tray lock on the handle catches to lock the
tray in place.
Battery Tray
Lock
Figure 12. Installing the Battery Trays
