Installation
Eaton 9135 5000/6000 VA UPS User’s Guide 164201726—Rev 4
www.eaton.com/powerquality
24
9.
Align each joining bracket with the adjacent cabinet screw holes and secure with the supplied screws (see
Figure 16).
Figure 16. Installing the Joining Brackets
10. If installing additional EBMs, repeat Step 6 for each cabinet.
11. Continue to the following section, “Installing the UPS.”
Installing the UPS
!
IMPORTANT
Do not make unauthorized changes to the UPS or accessories; otherwise, damage may occur to
your equipment and void your warranty.
See “UPS Rear Panels” on page 29 for the rear panel of each model.
To install the UPS and optional EBMs:
1.
If installing an optional EBM, continue to Step 2; otherwise, continue to Step 4.
2.
Verify that the EBM battery circuit breaker is OFF.
3.
Plug the EBM cable into the battery connector. Plug the EBM communication cable into the RJ-11 port.
See Figure 17.
Up to four EBMs may be connected to the UPS.
NOTE
Joining brackets are required for installations with two or more cabinets.
Joining Bracket
