Eaton PDI WaveStar TFA STS 250-600A, Installation And Operation Manual

Page: 101 / 150

Eaton PDI WaveStar TFA Static Transfer Switch Installation and Operation Manual P-164001113—Rev 01 87
Figure 49. TIME Screen
To have the STS use Simple Network Time Protocol (SNTP), follow these steps:
1. Press Time button at the bottom of the screen. The TIME screen displays (See Figure 49 ).
2. Press the Server button. Enter the time server’s IP address.
3. Press the Zone button. Enter the time zone offset from Coordinated Universal Time (UCT) (-4 is Eastern
Daylight time).
4. Make sure the Use SNTP Server checkbox has a green check. Touch Use SNTP Server to toggle
between the green check (√) (use SNTP Server) and red X (do not use SNTP Server).
5. Press Get to initialize time and verify that Time Synchronization is working.
6. Touch Set to confirm date/time.
7. Touch Save to save settings.
1122..44 S SN NM MP P
The STS supports SNMP over its Ethernet connection. The STS sends a single trap, a summary alarm, if any
alarm condition is raised on the STS. Touch the
SNMP button on the Home Screen to display the SNMP
Screen (Figure 51). Touch MORE to display additional buttons if SNMP button doesn’t show.
System Setup: Networking