Eaton i-on40H+, Administration And User Manual

Page: 48 / 67

User Menu Options
Page 44
Testing outputs
Master and admin users can use Test
– Outputs
to test outputs the installer
has configured as "User Defined". The outputs may be used to control
external devices, such as lights or locking equipment.
Note: You can activate or deactivate user-defined outputs at any time (see
page 61).
To carry out the test:
1. Select Test
– Outputs
.
The display shows the first in a list of any user-defined outputs
allocated for your use. For example:


The top line shows the address and type of the output. In the above
example, the address is PAN>01 and the type is W (wired). The
output type is displayed for control units that have built-in radio and
wired outputs. The bottom line shows the name of the output (which
may be the same as the address) and whether the output is currently
on or off.
2. Press

or

to select the output.
3. Press

to switch the output on, and

again to switch it off. Check
that the output is working as expected. Outputs operated via radio
may take several seconds to change state.
4. Press

to end the test.
Testing remote controls
Master and admin users can use Test
– Remotes
to test remote controls.
To carry out the test:
1. Select Test
– Remotes
.
The following is displayed:


2. Press and hold a button on the device you wish to test until the
transmit LED on the device flashes.