DOCUMENT 1218
REV. B
Instruction Manual
AGS-LED
312 LED Series
300mm and 400mm
24
10.6.1
LED Strip Replacement Procedure
a.
Remove the M10 bolts, washers, and rain caps from the desired top frame section, see
Figure 29, pg. 56.
b.
Carefully lift up the extrusion, see
Figure 29, pg. 56
. Note, the LED strip wires are still
connected. Lift carefully to avoid damage to the LED strips, lenses, are connecting wires.
WARNING:
WARNING
Lift carefully when removing the top horizontal frame section. The
horizontal frame section houses soldered LED connections which can
be damaged if the frame section is lifted or removed abruptly.
c.
Detach the LED strip connectors, on both ends if necessary, see
Figure 30, pg. 57
.
d.
Remove the top extrusion from the sign and rotate 180°. Slide the desired LED strip
assembly, lenses, and lens clips out, see
Figure 30, pg. 57
.
e.
Slide the replacement LED strip into the channel, see
Figure 32, pg. 59
. Note, the lens
sections are designed to break into thirds and may break at the joint whilst handling. If a
lens section breaks during assembly, simply place a lens clip between the two detached
sections, and continue as prescribed. See
Figure 28, pg. 55
, for all possible lens
configurations.
f.
Rotate the horizontal frame section 180° to its original position and reconnect the
previously detached wire connections, see
Figure 32, pg. 59
. Use the LED wiring
diagrams,
Figures 53 – 57, 59, 61 & 62, pgs. 80-83, 85, 87 & 89
, if needed.
g.
Lower the horizontal frame section back onto the sign, see
Figure 33, pg. 60
.
h.
Reassemble the M10 bolts, lock washers, and rain caps onto the sign. Tighten and re-
torque the bolts. See
Table 18, pg. 91
, for torque values.