DOCUMENT 1218
REV. B
Instruction Manual
AGS-LED
312 LED Series
300mm and 400mm
14
10.4.2
Legend Panel Replacement Procedure (Method 2)
a.
Remove the top four sets of M10 bolts and lock washers from the top of the frame as
shown in
Figure 23, pg. 50
.
b.
Carefully lift up the horizontal frame section, see
Figure 23, pg. 50
. Note, the LED strip
wires are still connected. Lift carefully to avoid damage to the LED strips, lenses, and
connecting wires.
WARNING:
WARNING
Lift carefully when removing the top horizontal frame section. The
horizontal frame section houses soldered LED connections which can
be damaged if the frame section is lifted or removed abruptly.
c.
Detach the LED strip connectors, on both ends if necessary, see
Figure 24, pg. 51.
d.
Remove the top frame section from the sign.
e.
Remove the damaged legend panel as shown, see
Figure 25, pg. 52.
f.
Slide the replacement legend panel into the channel, see
Figure 25, pg. 52.
If the
previously removed reflector panel contained a notch, install the new reflector panel,
notch side down, into the bottom extrusion, and slide into the correct location.
g.
Replace the rain caps and vertical frame section to the original positions, see
Figure 26,
pg. 53
. Fasten and re-torque to the appropriate values, see
Table 18, pg. 91.