Maintenance 49
2. Bend the wire toward the center and insert it around the z-bend next to the center
space. (Space D in the following illustration.)
3. Pull the strand wire through the mesh and straighten it with pliers.
4. Repeat the above three moves until you reach the side edge of the belt.
5.
Using the pliers, connect the strand’s edge loop to the belt’s edge loop on the far
edge.
6. Connect the edge loop on the near edge of the belt to the s
trand’s edge loop.
7. Straighten the strand with the pliers.
Step 3
– Weave the Strand to the Other Side
1. Repeat the steps in Step 2, going in the opposite direction, weaving to the other
side edge of the belt as shown in the following illustrations.
A
E
C
B
D
2
4
1
5
3
A
E
C
B
D
1
5
3
2
4
Summary of Contents for Combination EC Series
Page 2: ......
Page 4: ......
Page 73: ...Appendix A Electrical Schematic 73 Electrical Schematic L Sealer ...
Page 81: ......
