![background image](http://html1.mh-extra.com/html/eagle-eye-power-solutions/gfl-1000/gfl-1000_user-manual_3284128009.webp)
GFL-Series User Manual V1.1
8
www.eepowersolutions.com | Tel: 1-877-805-3377 | Fax: 1-414-962-3660 | [email protected] | V1.1
Remove the Signal Receiver from the case. Switch it on using the slide switch on the
left side of the unit. Check that the display is lights and the battery is charged. The state
of charge is indicated by the icon in the top right hand corner of the display. If
necessary, charge the battery by connecting the smaller power supply for the Signal
Receiver to the DC supply connection at the base of the receiver.
The Signal Generator in the main case can be switched on using the power switch on
the front panel. The state of charge is indicated by the icon in the top right hand corner
of the display. It may be charged using the larger power supply which plugs into the
right hand side of the case.
Both units may be charged while switched off. When the units are fully charged the
indicator on the power supply changes from red to green.
The batteries will last for approximately 4 hours in normal use.
4.1 Navigation
There are several ways to navigate through the menus. In all cases
Ent
or
Enter
will
carry out the action, while
Esc
will go to the previous screen.
On the Signal Generator, use the arrows to move around the screen or change values.
On the Signal Receiver, the screen is touch sensitive and selections may be made
using fingers or (more easily) the stylus provided at the top back of the unit. The keypad
may also be used, and the buttons at the side duplicate the up, down, enter and escape
functions. Be sure to remove the protective transparent screen cover for best visibility
and touch performance.