![background image](http://html1.mh-extra.com/html/eagle-eye-power-solutions/gfl-1000/gfl-1000_user-manual_3284128018.webp)
GFL-Series User Manual V1.1
17
www.eepowersolutions.com | Tel: 1-877-805-3377 | Fax: 1-414-962-3660 | [email protected] | V1.1
Figure 4-9 Current Clamp Position for Reference Calibration
Allow the measurement to stabilize for five seconds, then select
Set ref
on the signal
receiver screen. The display will state
Setting Ref…
and after a few seconds will
indicate
Setting Done!
All subsequent measurements will now be referenced to this
Signal Generator output value, defined as 100%.
Figure 4-10 shows a typical reading in the signal receiver display before and after the
Reference is set. The more red bars, the greater the signal strength. The reference may
be reset at any time.