Installation, Operation and Parts Manual
EE-62CE-60T
23
5.2 Operation instructions
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift. After reviewing these
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift. Always lift the
vehicle using all four adapters. Never raise just one end, one corner or one side of vehicle adapters. The lift must be only used in a
static position for lifting and lowering vehicles.
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be midway between adapters and centered over the
lift. Always use safety stands before removing and installing heavy component which may cause uneven load distribution.
1. Park the vehicle between two posts.
2. Adjust the lifting arms until lifting trays are under the pick-up positions of the vehicle and make sure the gravity of vehicle located
over the center of four lifting arms.
3. Turn on the main power switch.
4. Push the UP button on the control box until lifting adapters have touched the pick-up positions of vehicle.
5. Keep on raising the vehicle making its wheels have a bit clearance off the ground and check again the stability.
6. Raise the vehicle to the height excepted, push the “Safety Lock” button to engage the mechanical safety locking unit. Check again the
stability and then perform maintenance or repair work underneath.
Lower the lift
When lowering the lift pay careful attention that all personnel and objects are kept clear.
1. Push the “DOWN” button on the control box. Meanwhile the lifting arms automatically go upwards about 5CM which releases the
mechanical safety locking unit. After that the lift starts descending.
2. When the lift is fully lowered, position the lift arms and adapters to provide an unobstructed exit before removing vehicle from lift
area.
3. Drive the vehicle away.
APS function
In the case the mechanical locking unit is released, push APS button and DOWN button for direct lowering.
Pos.
Name
Function
QS
Power switch
Control main power
HL
Power indicator
Show if electricity is connected
SB1
UP button
Control the rising movement
SB2
Safety lock button
Engage the mechanical safety lock
SB3
DOWN button
Control the lowering movement
SB4
APS button
Use together with SB3 for direct descent
