Page K-4
ELECTRICAL COMPONENTS & WIRING
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Warnings and Dangers.
B
Fig. 7 Motor Connections
23.Remove main wiring harness from the vehicle.
24.Install new main wiring harness making sure that it fol-
lows the proper path.
a) Starting in the middle of the vehicle, route the for-
ward section of the harness under the rear body in
the floorboard channels (1 & 2).
b) Route the connections for the brake and accelera-
tor pedals, making sure that the harness lays in the
recessed floorboard channels.
Fig. 8 Harness Routing & Pedal Connections
c) Connect the wires to the accelerator rotary position
sensor (5) and the throttle enable switch connector
(4).
d) Place pedal assembly in position on the floorboard
and secure with three Torx screws (6).
e) Connect the wires to the brake pedal rotary posi-
tion sensor (8).
f) Place pedal assembly in position on the floorboard
and secure with four socket head hex screws (10).
g) Route the remaining wires in the floorboard chan-
nel that runs up under the instrument panel.
h) Feed the connectors for the key switch, the speed-
ometer, the rabbit/turtle switch and the diagnostic
plug through the opening in the cup holder base
(12). Place the diagnostic plug (13) into the cup
holder base and route the connectors for the key
switch (14), the speedometer and the rabbit/turtle
switch over the front splash shield.
Fig. 9 Cup Holder
i) Route the wires (14) for the key switch and the
speedometer through the guide (15) on the front
splash shield and the connectors for the key switch
and the speedometer through the opening (16) in
the back of the instrument panel.
l.
Fig. 10 Front Splash Shield
MOTOR
33
32
31
4
10
6
8
6
1
2
5
14
12
13
14
15
16
