BATTERY CHARGER
Page I-3
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Warnings and Dangers.
B
B
3. Unplug the cord (1) from the charger receptacle to the
charger.
4. Unplug the Charger DC Output connector (2) and the
DC-DC Output connector (3).
5. Place a rubber mat over the exposed battery pack.
6. Remove the four flanged hex head bolts (4) and lock-
ing nuts (5) securing the charger to the charger brack-
ets.
7. Lift the charger carefully and place it so the nut (6)
securing the green ground wire to the charger can be
removed.
Installation
8. Connect the green ground wire to the stud on the front
flange of the charger and secure with hex nut (6).
Tighten to the specified torque.
9. Lower the charger down between the brackets and
the battery pack, install four flanged hex head bolts (4)
and secure with locking nuts (5). Tighten hardware to
the specified torque.
10. Plug in the charger DC output connector (2) and the
DC-DC coutput connector (3).
11. Plug in the cord from the charger receptacle (1).
12. Remove the protective rubber mat from the battery
pack.
13. Install the seat bottom.
ITEM
TORQUE SPECIFICATION
5
53 - 79 in. lbs (6 - 9 Nm)
6
13 - 15 in. lbs (1.5 - 1.7Nm)
