294
E-MU Systems
Save/Copy Menu
Duplicate Flash
Duplicate Flash
This utility allows you to duplicate Flash SIMMs using MP-7. Both Sound
and Preset data is copied when a Flash SIMM is duplicated. A factory sound
SIMM cannot be copied using this utility.
WARNING: dangerous voltages are exposed inside MP-7!
Make sure
power is completely disconnected from MP-7 before removing the top
panel.
Replace the top panel before restoring power to the unit.
The two sound SIMM sockets in MP-7 are marked 0 and 1. These are located
behind the controller knobs on the circuit board. The Flash SIMM you want
to copy MUST be placed into SIMM Socket 0. The destination Flash SIMM
must be placed in SIMM socket 1.
1.
Make sure the two Flash SIMM are located in the required MP-7 SIMM
sockets.
_
_
_
_
If there are no Flash
SIMMs in the unit, or if the
SIMMs are in the wrong slots,
an error message will be
displayed.
2.
Press the
Save/Copy
menu button.
3.
Rotate the data entry control to select the
“Duplicate Flash SIMM”
screen shown above.
4.
Move the cursor
to the bottom line and press
Enter
. The following
screen appears and the Enter LED will be flashing.
5.
Press
Enter
again to confirm or any other button to abort. The
following screen appears and the SIMM is copied.
6.
When MP-7 has finished duplicating the SIMM, turn power off, remove
the copied SIMM, then
reboot
. That’s it!
DUPLICATE SLOT 0 FLASH
Start
Press ENTER to overwrite
the Flash SIMM in Slot 1
DUPLICATING SLOT 0 -> SLOT 1
(Takes about 5 minutes)
Summary of Contents for MP-7 command station
