EN
7
RTF/BNF Basic
IMPORTANT:
The installed receiver
has been programmed for operation
specifi cally in this aircraft.
To operate the SAFE
®
or SAFE
®
Plus
(optional) system in this aircraft, set
up your optional DSMX
®
/DSM2
®
transmitter using the chart below.
- SAFE Flight mode is selected
using the B Switch (Gear/ Ch 5)
- Holding Pattern and AutoLand
are selected using Button I*
(Aux1/ Ch6)
IMPORTANT:
A transmitter with a
2-position Channel 5 switch will only
allow the use of position 0 (Beginner
Mode) or position 2 (Experienced
Mode) fl ight modes. If possible
assign Channel 5 in your transmitter
to a 3-position switch to operate
all 3 fl ight modes (refer to your
transmitter’s manual).
Refer to your transmitter’s manual for
more information about transmitter
setup.
*Holding pattern and Autoland are
only available with the optional GPS
module
Transmitter Setup
Computerized Transmitter Setup
Start all transmitter programming with a blank model setup (do a
model reset), then name the model.
Set Aileron
and Elevator
Rates to:
HIGH 100%
LOW 70%
DX6e
DX6
DX7 (Gen2)
DX8e
DX8 (Gen2)
DX9
DX18
DX20
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Go to CHANNEL ASSIGN:
click NEXT to go to Channel Input
Confi g: GEAR: B, AUX1: I
4. Go to the FUNCTION LIST
5. Go to throttle cut:
Assign the switch to the H switch
Set the cut off position to -130%
iX12
1. Touch the Model Setup tab from the main screen
2. Select Channel Assign;
Assign Gear (5) to Switch B
Assign Aux1 (6) to Switch I
3. Exit back to the main screen
4. Touch the Model Adjust tab from the main screen.
5. Select Throttle Cut:
Assign the switch to the H switch
Set the cut off position to -130%
Resulting in:
I Button
HP/AL button
Switch B
Flight Modes
Switch B
operates the 3 SAFE Plus modes (0 begin-
ner/1 intermediate/2 experienced)
Button I
commands Holding Pattern/Autoland*
®
