EN
20
Optional SAFE+ GPS Upgrade
GPS MODULE INSTALLATION:
(continued)
5. Remove the piece of hook and loop tape
applied to the bottom of the battery
compartment from the factory.
6. Apply a piece of double side tape on the
bottom of the GPS circuit board and the GPS
antenna.
7. Mount the circuit board and antenna in the
nose of the aircraft, as show below.
8. Lay the wires into the channel in the bottom
of the battery compartment, and apply the
provided piece of adhesive backed hook and
loop tape over the channel to hold them in
place.
9. With the GPS in the aircraft, install the battery further back for fl ight, as shown.
10. Verify the Center of Gravity is in the correct location 60 – 68mm back from the leading edge
break, before fl ying.
IMPORTANT:
The GPS antenna should be installed fl at in the fuselage facing upward, as shown below.
IMPORTANT:
Do not kink or cut the GPS antenna cable. Antenna wires are coaxial wires, kinks or cuts
will degrade performance.*
60 – 68mm
GPS
Antenna
Hook and loop tape
Double sided tape
SIDE VIEW
TOP VIEW
GPS and Battery Placement
GPS
Circuit Board
BATTERY
*
*The antenna connector may need to
be rotated slightly during installation to
prevent disconnecting the antenna or
kinking the antenna cable. It has black
rubber glue on the connector, but will
allow for some fl ex for slight rotation.