EN
6
Remove the battery cover. Install the four
included batteries (noting proper polarity) and
reinstall the battery cover.
Transmitter
Low Battery Alarm
When the battery voltage drops
too low, an alarm sounds and the
LED fl ashes. The batteries must be
replaced immediately. If this happens
while fl ying, land your aircraft as soon
and as safely as possible.
Transmitter Batteries
Installation
Throttle /
Rudder/
Power LED
Battery Door
Power
Switch
Elevator Trim
Down
Ailerons /
Elevator/
Press for
Dual Rates
Aileron
Trim Right
Elevator
Trim Up
Aileron
Trim Left
Throttle
Trim Down
Rudder
Trim left
Throttle
Trim Up
Rudder
Trim Right
Flight
Mode
Switch
Bind /
HP/AL*
Trigger
Mode 2 shown
* (HP) = Holding Pattern (AL) = AutoLand
Holding pattern and Autoland are only
available with the optional GPS module
The included transmitter comes
pre-bound to the aircraft.
CAUTION:
NEVER remove the transmitter batteries
while the model is powered on. Loss of model control,
damage or injury may occur.
CAUTION:
If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in injury
to persons and/or damage to property.
CAUTION:
Risk of explosion if battery is replaced by
an incorrect type. Dispose of used batteries according
to national regulations.
The included DSMX
®
transmitter features dual rates to
allow you to select the amount of travel that you want from
the control surfaces. Press the Aileron/Elevator stick into
the transmitter to change between low rate and high rate
mode for elevator and aileron. Low Rate is indicated by the
Power LED fl ashing, on High Rate the LED will be solid.
Dual Rates
Dual Rate High Rate Low Rate
Aileron
100%
70%
Elevator
100%
70%
