Dynapac V5100TV, Operation & Maintenance Manual

Page: 121 / 152

E 35
7.2 Adjusting the tamper deflector plate
Before each laying operating, check the
tamper adjustment.
The tamper knife (1) should touch the
knife bar ((2) on the screed).
The play (a) between the tamper deflec-
tor plate (3) and the tamper knife (1)
should be 0.5 mm across the entire
width.
If correction should be necessary, pro-
ceed as follows:
A
Two adjustment points per screed part!
Adjusting the tamper deflector plate:
- If readjustment is required, loosen the
nut (4) and the slotted nut (5).
- Adjust play by turning the support
tube (6):
- Screw it in to increase the gap.
- Screw it out to reduce the gap.
- Firmly tighten the nut (4).
- Check play. If necessary, repeat the
adjustment procedure.
- Then firmly lock the slotted nut (5).
7.3 Adjust sliding plates
A
The sliding plates only need to be adjus-
ted if they have been replaced.
For new installation, the play (a) bet-
ween the tamper knife (1) and the sli-
ding plate (2) should be 2.0 - 2.5 mm
across the whole width.
EB51_Verstell6.bmp
3
1
a
2
6 4 5
6 4 5
1
a
2