Dynapac V5100TV, Operation & Maintenance Manual

Page: 120 / 152

E 34
7 Settings
7.1 Adjusting the tamper height
Before each laying operating, check the
tamper adjustment.
The tamper knives (A) must be located
at bottom dead centre flush with the in-
clined edges of the sliding plates (B).
If correction should be necessary, pro-
ceed as follows:
A
Two adjustment points per screed part!
Adjust tamper lower:
- Loosen the mounting screws (1) of the
tamper bearing brackets
- Loosen screw (2)
- Turn screw (3) clockwise until the de-
sired setting is achieved
- After making the adjustment, retighten
screw (2) under all circumstances.
- Tighten the mounting screws (1) of the
tamper bearing brackets.
Adjust tamper higher:
- Loosen mounting screws (1) of the
tamper bearing brackets.
- Loosen screw (2).
- Turn screw (3) counter-clockwise until the setting is correct.
- After making the adjustment, retighten screw (2) under all circumstances.
- Tighten the tamper bearing bracket mounting screws (1).
EB51_Verstell6.bmp
A
B
3
2
1