Dynapac ICA362, Instruction Manual

Page: 111 / 121

Maintenance - 1000h
ICA362-4EN3.pdf 2012-06-12
Fuel tank - Drainage
Fig. Fuel tank
1. Drain plug
1
Water and sediment in the fuel tank are removed via
the drainage plug in the bottom of the fuel tank.
Be very careful during draining. Do not drop the
plug or else all the fuel will flow out. Be very careful during draining. Do not drop the
plug or else all the fuel will flow out.
Drain the roller after it has been stationary for a long
time, e.g. after standing overnight. The fuel level
should be as low as possible.
The roller should preferably have been standing with
this side somewhat lower, so that water and sediment
will gather near the drainage plug (1). Drain as follows:
Place a container under the plug (1).
Remove the plug and drain the water and sediment
until only pure fuel runs from the plug. Refit the plug.
Rear axle differential - Oil change
Fig. Rear axle
1. Level/Filler plug
2. Drain plugs
1
2
Never work under the roller when the engine is
running. Park on a level surface. Block the wheels
securely. Never work under the roller when the engine is
running. Park on a level surface. Block the wheels
securely.
Wipe clean and remove the level/filler plug (1) and all
three drain plugs (2), and then drain the oil into a
suitable receptacle. The volume is approx. 12 liters
(12.7 qts).
Save the oil and dispose of it in an
approved manner. Save the oil and dispose of it in an
approved manner.
Refit the drainage plugs and top up with fresh oil until
the correct level is reached. Refit the level/filler plug.
Use transmission oil, see Lubricant Specification.
101