Dynapac F1200C, Operation & Maintenance Manual

Page: 164 / 296

D 40.12 12
After starting
m
Let the paver finisher warm up for approx. 5 minutes if the engine is cold.
Observe indicator lamps
The following indicator lamps must be observed under all circumstances:
For further possible faults, see Engine operating instructions.
Battery charge indicator (1)
Must go out after starting.
m
If the lamp does not go out or lights up during operation: Briefly rev up the engine.
A
The engine speed can be increased by switching on a conveying function.
If the lamp remains on, turn the engine off and ascertain the fault.
For further possible malfunctions, refer to the section "Malfunctions".
Error message (2)
A
Lights up for a few seconds once the ignition has been switched on for
checking purposes.
m
If the lamp does not go out or lights up during operation: switch off engine immediately
and determine fault.
A
Depending on the type of fault, the vehicle can temporarily continue to be operated
or, in the case of serious faults, should be shut down immediately to prevent further
damage from occurring.