Dynapac F1200C, Operation & Maintenance Manual

Page: 162 / 296

D 40.12 10
- Possibly start the engine of the vehicle supplying power and leave to run for a while.
Now try to start the other vehicle:
- Turn ignition key (3) to position 1 and wait for the preheat check (9) to go off.
- Turn the ignition key (3) to the starting position start the engine.
Do not let the starter run permanently for more than 20 seconds, then allow for a
break of one minute!
A
If the engine does not start and the Error message (5) indicator lamp flashes, then the
electronic engine control system has activated the start inhibit.
To deactivate the start inhibit, turn the system off with the ignition key (3) for
approx. 30 s.
- If the engine still has not started after two attempts, ascertain the cause!
- If the engine starts up: disconnect the start aid cable again in reverse order.