Dynapac CC1300C, Instruction Manual

Page: 49 / 128

Operation
4812161201_F.pdf 2018-04-17
Starting
Starting the engine
1
2
3
6
20
29
31
Figure. Control panel
1. Starter switch
2. Throttle control
3. Emergency stop
6. Forward/Reverse lever
20. Vibration switch man/auto
29. Glow lamp
31. Parking brake
The operator must remain seated when starting. The operator must remain seated when starting.
Make sure that the emergency stop (3) is pulled out
and the parking brake (31) is activated.
Set the forward/reverse lever (6) in neutral. The
engine can only be started when the lever is in neutral.
Set the vibration switch (20) for manual/automatic
vibration in (position O).
Do not run the starter motor for too long. If
the engine does not start, wait a minute or so
before trying again. Do not run the starter motor for too long. If
the engine does not start, wait a minute or so
before trying again.
At high ambient temperatures, set the throttle control
(2) to the position just over idling.
Set the throttle control (2) to full speed when starting a
cold engine. Preheating: Turn key to position II. When
the glow lamp (29) goes off: Turn the starter switch (1)
to the right. As soon as the engine starts, release the
starter switch and reduce the engine speed to just
over idling (because high revs can damage a cold
engine). As soon as the engine is running smoothly,
reduce the revs down to idling.
Warm up the engine at idling speed for a few minutes,
although longer if ambient temperature is below +10°C
(50°F).
39