11
Installation
To attach the mounting arm to the chair:
A mounting bracket is not supplied. It is the responsibility of the manufacturer/dealer to
design and make a suitable bracket for attachment to the chair. The mounting arm must be
attached to this bracket using only the M10 bolt and washers supplied by D
YNAMIC
C
ONTROLS
.
Torque the M10 bolt to 15 Nm.
CAUTION
Use only the M10 bolt and washers supplied by D
YNAMIC
C
ONTROLS
. Do
not substitute with parts of lesser quality. This bolt must be tightened to
a torque of 15 Nm. Do not omit the washers. The mounting arm may
become loose if these instructions are not followed.
3.1.2
Mounting the module
The iPortal module can be mounted anywhere on the wheelchair, using two M4 bolts and
lock nuts to secure the module to the frame of the chair. However, the following should be
taken into consideration:
ease of access by the wheelchair user
the length of the charging cable
the orientation of the module
routing of the DX or DK bus cable
sufficient clearance around the Apple USB port
sufficient clearance around the auxiliary USB charging port
Only two orientations of the module are permitted, as shown in the diagrams on the next
page.
M10 bolt (torque to 15Nm)
Mounting bracket (not supplied)
