DynaGen TG410, User Manual

Page: 5 / 67

Introduction
4
© 2017 DynaGen Technologies Inc TOUGH Series Manual
1 Introduction
The TOUGH series controllers are designed to provide complete control, protection, AC metering, and engine instrumentation for
both standard and electronic engines. The module is easily configured using either the front panel buttons or our DYNAGEN
Configurator software. TOUGH series controllers are ideally suited for severe duty applications where reliability is critical such as
mobile and stationary generators.
Features and Functions:
·
5 Year Warranty
· SAE J1939 CAN Bus Protocol
· RPM via J1939, Magnetic Pickup, or Generator
·
Speed control offset for electronic engines
· Autostart on low battery and other sensors
·
Trim feature for AC monitoring and sensors
· Maintenance counter
· Exerciser Clock
·
150 Event Log
· Conformally coated for protection against moisture
·
Gasket for water ingress protection resistance
· Free RapidCore Configuration Software
· Fast and rugged installation clips
·
Passcode protected
· Automatic shutdowns and warnings
·
Manual and Remote start
· Momentary Start / Stop inputs
· Pre-heat and many other configurable timers
·
Accepts common senders (VDO, Datcon, S&W)
· Custom senders configurable with DYNAGEN
Configurator
Displays:
·
Engine Temperature
· Oil Pressure
· Fuel Level
·
Engine Speed
· AC Metering
· Battery Voltage
·
Real Time Clock
· Engine Hours
· Time to Maintenance
·
J1939 DTCs + Custom Text
· Custom Senders
· Warnings and Failures
Feature Included
DPF / DEF Ready
J1939 CAN Bus
Isolated RS485 Modbus
Magnetic Pickup Input
150 Event Log
Clock / Exerciser
Generator Voltage Metering Single or 3-Phase
Generator Current Metering (with IDMT and Load Imbalance features) Single or 3-Phase
Configurable Switched Inputs 5
Resistive Sensors (1 High Ohm, 1 Low Ohm) 2
Universal Sensor (Resistive, 0-5V, 4-20mA) 2
5V Sensor Output for Electronic Sensors
Configurable Switched Outputs 6