DynaGen TG410, User Manual

Page: 39 / 67

Settings
38
© 2017 DynaGen Technologies Inc TOUGH Series Manual
Speed Control Instructions
When the controller is running and there are other functions occurring, the controller will scroll through its display parameters as
usual. When the speed control page is displayed, it will show the Engine Speed as well as the following instructions: Hold AUTO +
Up/Down to Adjust RPM.
Speed Control Parameter Page Speed Control Adjust Page
Pressing and holding the AUTO button will display the screen to the right. If a 'Display Adjust Parameter' is set, it will also be
displayed underneath the Engine Speed. While still holding the AUTO key, press the up or down arrows to adjust the RPM. The
Engine Speed display should update as the engine physically changes its speed to accommodate the speed request.
NOTE : When using switched outputs for speed control, the Set RPM will display '---' instead of the set speed.
4.4.5
Battery Level
Use the following settings' configurations to allow the controller to read and interpret the battery voltage level.
Name Range Description
Battery Recharge Enable ~ Disable Enables or disables the ability to have the engine start on low
battery voltage in order to charge it.
Recharge Setup -> Level 6.0 - 30.0V Voltage level at which the controller starts the engine to
recharge the battery.
Recharge Setup -> Pre-Alarm 1 ~ 30 minutes Amount of time to display a warning before starting the engine.
Recharge Setup -> Duration 10 ~ 900 minutes Amount of time to run the engine.
Setpoints -> Low Warning 6.0 ~ 24.0V Reading at which a warning occurs.
Setpoints -> Low Failure 6.0 ~ 24.0V Reading at which a failure occurs.
Setpoints -> High Warning 12.0 ~ 32.0V Reading at which a warning occurs.
Setpoints -> High Failure 12.0 ~ 32.0V Reading at which a failure occurs.
Crank Low Batt 6.0 ~ 24.0V Screen displays a 'Low Voltage During Cranking' warning if
voltage dips below this level during cranking.
NOTE : When the engine is running, the battery voltage will equal the alternator charging voltage. The actual open-
circuit battery voltage may be lower than displayed.
Battery Recharge Sequence