dymax PrimeCure 385 nm Array, User Manual

Page: 25 / 32

25 UVCS LED Light-Curing Conveyor Systems User Guide
4. Any contamination that is visible should be removed by cleaning with a lint free cloth and
Isopropyl Alcohol.
5. Adhesive that is cured and adhering to the surface of the glass lens requires careful removal or
replacement of the lens using a replacement kit.
Dymax Kits
Quartz Optic Lens Single Head 43413
Quartz Optic Lens Dual Head Kit 43563
6. Once complete carefully reassemble the AX-550 units into the cradle and verify function prior to
starting any curing processing.
Troubleshooting
The BlueWave® AX-550 flood system constantly verifies its performance. If a problem is detected, a
diagnostic screen is displayed. Refer to the
BlueWave® AX-550 User Guide for error code definition.
Please take note of the contents of the screen and contact Dymax for support.
Table 1. Troubleshooting – BlueWave® AX-550 Issues
Problem Possible Cause Corrective Action
Unit does not power up The power cord is not plugged
in or damaged Check the connections and condition of the power
cord
The onboard fuse is blown Check onboard fuse
There is no electrical power at the
receptacle Test the receptacle for power
Unit powers up but LED is
not producing light The LED intensity adjustment is set
to the minimum Increase the LED intensity setting.
Controller is not mated with emitter
correctly Recheck the BlueWave® AX-550 assembly for
connection. Inspect for bent pins on the interface
connector.
The activation switch on the
conveyor is not in the “on” position
Verify that they activation switch is in the “on”
position
Unit is operating
normally, and LED
suddenly stops producing
light The over-temperature shutdown
was triggered Check that the flow of cooling air into the power
supply or array is not restricted.
If the LED does not illuminate after restarting,
contact Dymax Application Engineering
LED array provides only
low-intensity light The LED intensity adjustment is set
to the minimum Increase the LED intensity setting
The lens optics are contaminated/
dirty Clean the surface of the lens
Lamp height may have changed
since last operated Verify the lamp height and adjust as needed