10
11
W
W
W
.
D
Y
E
P
A
I
N
T
B
A
L
L
.
C
O
M
W
W
W
.
D
Y
E
P
A
I
N
T
B
A
L
L
.
C
O
M
RIZE CZR
™
B OA R D
SE TTI NGS A ND F UNC TI O NS
BLUE - Rate Of F ire ( ROF )
Values 1 - 30
The ROF setting is used to set the maximum rate of fire of the RIZE™.
The values do not correspond directly to a certain Balls Per Second
( BPS) value. You will need to use the table below to locate your
desired maximum ROF setting.
The factory setting is
3
(
10 .0 bps
).
Increasing ROF too high will increase probability of ball breakage.
If this occurs decrease ROF setting.
YELLOW - F iring Mode
Values 1 - 4 (default 1)
This setting changes the firing mode of the RIZE ™. Default is
semiautomatic. In the semiautomatic mode, one trigger pull
shoots out one paintball. The PSP mode and the Millennium
mode follow the rules of the paintball tournament series.
Value 1
-
Semi- automatic Mode
Value 2
-
Millennium Mode
Value 3
-
PSP Mode
Value 4
-
Full auto with first shot safety feature
RIZE CZR
™
B OA R D
SE TTI NGS A ND F UNC TI O NS
GREEN - Trigger Sensitivity
Values 1 - 20 ( factory default 5)
Trigger sensitivity is the amount of time that the trigger has to be
released before the next trigger pull is allowed. In some situations
with too low of a value, the RIZE™ can register more trigger pulls
than what was actually pulled. This can cause the RIZE™ to shoot full
auto, even in semi-automatic mode. To fix this, adjust the trigger
sensitivity setting higher.
RED - Dwell
Values 1 - 50 ( factory default 40 )
Dwell is the amount of time that the solenoid will be activated.
Follow these steps for the best way to set your dwell:
• Remove loader and any paintballs from the RIZE™ marker.
• With the dwell set at 20, start increasing the value until the marker
begins to fire.
• When you reach the setting where the marker begins to fire, get
some paint and a loader and go to a chronograph.
• Increase the dwell until you see no increase in the velocity.
This is the optimal dwell setting to be used.
NOTE: You cannot turn your marker off with the power button
when the marker is in configuration mode. You must first set DIP
switch 2 to the OF F position.
TRIGGER
PULLS
TRIGGER
PULLS
TRIGGER
PULLS
TRIGGER
PULLS
TRIGGER
PULLS
1
2
3
4
5
6
BPS
BPS
BPS
BPS
BPS
