18
19
W
W
W
.
D
Y
E
P
A
I
N
T
B
A
L
L
.
C
O
M
LOA D E R S A ND F E E D NE C K
A I R / NI TR O GE N
AIR / NITROGEN TANK OPTIONS AND INSTALLATION
The RIZE CZR™ with Compressed air and Nitrogen air
systems such as the DYE Throttle® air system and will also
work with CO
2
. Do not use any other compressed
gas. The output pressure from the air system has
to be between 40 0 – 850 psi. If you are using CO
2
it is essential that the tank is fitted with an anti-
siphon tube to prevent liquid CO
2
from
entering the RIZE CZR™.
To install an air system, screw the tank into
the airport all the way as far as it will go.
To remove the air system screw out.
There will be gas leaking for a few
seconds while you screw the air system
out. Notice that even with the air
system removed there can be gas
inside the RIZE CZR™ and it can still
fire
a paintball. A lways treat the
marker as being live and never
point it to anything you don’t
intend to shoot at!
LOADERS AND FEED NECK
To achieve the maximum performance of the RIZE CZR™
you will need to use a motorized loader that force
feeds paintballs into the RIZE CZR™ marker, preferably the
Rotor™ Loader. Using a slower motorized loader or
a non-motorized loader will work, but the rate of
fi
re
and performance will be reduced.
CAM LEVER FEED NEC K
The Cam Lever Feedneck is adjustable to
fi
t any
standard loader.
To
fi
t a loader onto the RIZE CZR™,
fi
t your loader into
the adjustable feedneck and tighten Cam Level into
postion,
fl
ush with the feedneck collar.
Loader should now be held in with a snug
fi
t. If not, see below to adjust the Cam Lever tension.
To loosen the locking system and remove the loader, lift the cam lever away from the feed collar.
Take care not to over-tighten the cam locking system. The lever should not be overly dif
fi
cult to
lower into the locked position.
There is no maintenance needed for the feed neck besides keeping it clean of broken paint, dirt
and debris.
W
W
W
.
D
Y
E
P
A
I
N
T
B
A
L
L
.
C
O
M
To adjust the cam locking feed neck, lift the lever away from the feed collar. Using a 5/32" hex
wrench, turn the screw connected to the lever clockwise to tighten or counterclockwise to
loosen the grip on the loader. Once the desired adjustment has been made press the cam lever
down against the feed collar to secure the loader in the feed neck.
