20
21
W
W
W
.
D
Y
E
P
A
I
N
T
B
A
L
L
.
C
O
M
W
W
W
.
D
Y
E
P
A
I
N
T
B
A
L
L
.
C
O
M
HY P E R 3 ™ I N- L I NE R E GUL ATO R
A DJUSTME NTS A ND MA I NTE NA NC E
HYPER3™ REGULATOR DIS-ASSEMBLY INSTRUCTIONS
Before performing maintenance on the Hyper3™ regulator, ensure that the RIZE CZR™ is completely
degassed and then unscrew the Hyper3™ from the RIZE CZR™ marker.
To disassemble the Hyper3™ regulator you will need a C- clip tool or a strong pick. Remove the C-
clip from the bottom of the Hyper 3 reg. Next, unscrew the Brass seat housing from the body
with a 3
⁄
16” A llen key.
To change the seat, pull out the old seat from the housing with a sharp object. Insert the new seat
in place and push it down with a flat object. Notice that it takes about 20 0 0 shots for the seat to
perfectly sit into the seat housing. This is called the break in period for the regulator. Remember
to apply lube to the 010 on the brass reg seat housing before re- assembly. Further disassembly to
service the top section of the Hyper3™ should be performed by a trained Tech.
C-CLIP
SEAT HOUSING
BODY
0 14 BN0 70
REGULATOR SEAT
TOP CAP
VELOCITY ADJUSTMENT
The velocity of the RIZE CZR™ is adjusted by adjusting the input
pressure into the RIZE CZR™. This is controlled with the Hyper3™
regulator. The Hyper3™ on the RIZE CZR™ is factory set to 145 psi which
will give you a velocity of about 285 FPS ( Feet per Second) .
A 3
⁄
16” allen key will be needed for this operation. Turning the
adjustment screw in ( clockwise) will decrease the pressure, and out
( counterclockwise) will increase the pressure. To adjust the
velocity:
1. Make sure you and everybody around you is wearing ASTM/ CE
approved paintball goggles.
2. Shoot the RIZE CZR ™ over a paintball chronograph.
3. To lower the velocity turn the Hyper3™ adjustment screw in. To
increase the velocity turn the screw out. Only turn the screw a
quarter turn at a time and shoot over the chronograph again.
Notice that a few shots are needed before the change can be
seen on the chronograph.
MAINTENANCE
For the RIZE CZR™ to function properly, it is essential that the input
pressure into the marker stays consistent at all times. The general
maintenance needed for the Hyper3™ regulator is to keep it clean
of dirt and debris at all times. A more extensive service should be
performed every 12 months by a trained Tech or if the output
pressure of the regulator becomes inconsistent. This can be seen
as inconsistent velocity and verified with a regulator tester ( sold
separately) . Notice that the Hyper3™ has a break in period of
about 20 0 0 shots before it achieves the best performance.
HY P E R 3 ™ I N- L I NE R E GUL ATO R
A DJUSTME NTS A ND MA I NTE NA NC E
