Quasar CM-3211/CM-4221 Series User and Installation Guide
12
5.3
Power and Ethernet Cable Connection
Power Connection
Make sure the camera’s power cable is properly connected. Refer to
Camera Connections
. If using
Power over Ethernet (PoE), make sure Power Sourcing Equipment (PSE) is available on the
connected network. All electrical work must be performed in accordance with local regulatory
requirements.
5.4
Initial Camera Configuration
To perform the initial camera configuration:
1.
Unpack the camera. Rotate and remove the protective cover.
2.
Remove the PE cloth sheet and lens cap. Attach the dome cover to the body.
3.
Connect one end of the Cat 5 Ethernet cable to the Ethernet port of the camera and the RJ45
connector at other end to the Power Sourcing Equipment (PSE) device, such as a switch.
4.
Verify that the RJ45 connector LEDs illuminate green (indicating a stable network connection)
and flashing yellow (to indicate network activity).
5.
Do one of the following:
Copy and run the dna.exe (see note below) from the included CD.
Note:
DNA is an enhanced software alternative to Device Search. Either of these programs
may be used. They are supplied on the included CD.
From the Latitude Sidebar, run the Unified Configurator by selecting
Applications > Device
Configuration Tool
and then, on the Unified Configurator screen, click
DVTEL HD Series
.
6.
Mark the unit requiring IP assignment.
Figure 7: Discovered IP Devices
