24
Step 4
- Install the interior assembly between the two parts. Place the
adjustable flanged band assembly toward the downstream section.
Step 5
-Assemble the outlet end sliding innerwall to the outlet end section
as a regular section (See JOINT ASSEMBLY section). See
Figure 36
.
Step 6
- Before assembling the double flanged sleeve to the inlet end
section, add a thin coat of sealant about 1” wide and a thin coat of
sealant at the unflanged end of the LV joint whee the joint slides into
the mating duct secion. Press sealant into any gap between the LV and
the mating joint section.
Step 7
-Assemble the inlet end flange assembly with the inlet end section
flange as a regular length installation (See
JOINT ASSEMBLY section
).
Step 8
- Apply thin layer of sealant inside the retaining collar, and also a
continuous bead of sealant at the collar overlap seam. See
Figure 37
.
Figure 36 -Step 4-5- Install the inner LV and secure the outlet end flange
Figure 37- Step 7-9- Secure the Double Flanged Sleeve
and seal the Retaining Flange Collar
Step 9
-Slide down the retaining band on the double flanged sleeve to
mate their flanges and tighten the retaining collar.
Step 10
-Then install the other V-band (BSI) over these flanges (like
regular joint assembly). See
Figure 38
.
Figure 38 - Step 10-11 - Secure the Retaining Flanged Band
Step 11
- Install the split outer casing that covers from the outer wall
of the inlet end section to the outerwall of the outlet end section. See
Figure 39
Figure 39 - Step 12- Install the Split Outer Casing
Split Outer Casing
