41
13. OTHER SETTINGS
(2)
Setting the double-feed detection sensor of the paper feeder B
Select to use the double-feed detection function of the paper feeder B, and set the paper thickness, double-
feed detection sensitivity, and position to start double-feed detection.
Turn the jog dial to display “B Tray Setting”, and press the jog dial to confirm the setting.
(a) Using the double-feed detection function
Turn the jog dial to display “B Tray Check”, and press the jog dial to confirm the setting.
Perform the same operation as when using the double-feed detection of paper feeder A.
(Refer to (a) in (1) on the before section.)
(b) Setting the thickness of the paper
Turn the jog dial to display “B Tray Thick”, and press the jog dial to confirm the setting.
Perform the same operation as when setting the paper thickness of paper feeder A.
(Refer to (b) in (1) on the before section.)
Select Thick
Auto Heavy Thin
Approximate settings (Paper feeder B)
Setting
Auto
Heavy
Thin
When paper thickness is 52 to 250 g/m
2
(standard)
If misdetection occurs when set to “Auto” for dark prints
If misdetection occurs when the paper thickness is less than 70 g/m
2
and set to
“Auto”
Condition (Approximation)
NOTE
:
Even when the double-feed detection function is set to “Off”, be sure to change the setting
according to the paper used.
If this setting is not appropriate, double-feeding will not be detected properly, and in
addition the paper feed error of the paper forwarding just a little and then stopping will
occur frequently.
If settings have been changed, be sure to perform test feeding.
(c) Setting the sensitivity of the double-feed detection
Turn the jog dial to display “B Tray Level”, and press the jog dial to confirm the setting.
Perform the same operation as when setting the double-feed detection sensitivity of paper feeder A.
(Refer to (c) in (1) on the before section.)
(d) Setting the position for starting the double-feed detection
Turn the jog dial to display “B Tray Position”, and press the jog dial to confirm the setting.
Perform the same operation as when setting the double-feed detection start position of paper feeder A.
(Refer to (d) in (1) on the before section.)
