24
Press the start button to start the process. Take note that pressing the start button for more
than 2 seconds starts test feeding. After processing the number of sets set, the machine will
stop.
To stop the machine halfway through, press the stop button. Pressing the stop button once
stops the machine after the set currently being processed has ended. Pressing the stop
button twice stops the machine even if a set is current being processed.
NOTE
:
The machine will not start if the number of sets set is the same as the number of sets already processed.
In such cases, press the
(Clear) button once, and set “0” for the number of sets already processed.
If the machine has been stopped by pressing the stop button twice while processing a set, it will start
processing that set from the beginning again when restarted.
7
6. OPERATIONS
Perform test feeding. This memorizes the features of the paper set in the machine.
As this step is required for double-feed detection, automatic size detection, and end mark
detection, be sure to perform this step.
q
Continue pressing the start button for more than two seconds, and release.
(Pressing the start button generates one short beep and another beep two seconds later. Release the button when the
second beep sounds.)
∗
The beep will not sound if the buzzer ON/OFF setting is set to “Off”.
w
When the double-feed detection function is set to “Set”, paper will be fed for the number of sets set. If set to “Sheet”, only
the first sheet of each paper feeder will be fed.
e
When using the end mark detection function and the double-feed detection function is set to “Sheet”, perform test feeding
after placing the paper printed with an end mark on the very top of paper feed tray A.
(Refer to “8-3. Printing the End Mark”.)
r
Check that the test-fed paper has been processed normally. If errors are found, correct the case, and test-feed again.
(Causes of the error include double-feed, different order of paper stacked, wrong number of sheets in set was entered,
etc.)
Return the paper ejected in test feeding to each paper feed tray in the same direction and order as when they were stacked
previously, or use the manual feed function of the downstream processing unit.
NOTE
:
If the paper used differs from the type used the last time (paper quality, thickness, size, color, or
printing state), be sure to carry out test feeding each time.
If the DBM-120 Sheet by Sheet is connected, the test-fed paper will be ejected without being processed.
If the DBM-400 Sheet by Sheet is connected, the test-fed paper will be ejected with being processed.
6
