Version 08.2017 | Page/ Seite 14
www.dunkermotoren.com
• Remove any cable ties that have been used to hold the cables in position.
• Release the D-type connector retaining clip as shown in Figure 3.3 and Figure 3.4
1. Connector
retaining clip
2. Release from
hook here
Figure 3.3
Figure 3.4
• Unplug the connector and remove the cable assembly from the module.
• Remove the cable assembly from the drag chain.
Replacement
Re-fitting the cable assembly is the reverse of the removal procedure.
• Plug in the replacement cable15-way D-type plug into the connector on the forcer and engage the connector
retaining clip as shown in Figure 3.3.
• Place the cable assembly inside the drag chain.
•
Fit new cable ties to secure the cables as originally fitted.
• Re-clip the drag-chain covers that were previously unclipped.
•
Reconnect the cable assembly to the Accelnet Micro Panel Amplifier.
