16
BLUEHEAT™ SYSTEM__________
UNCONTROLLED IF PRINTED
QSP-711-101
SBS™ MODES
The SBS™ has 3 different modes that a diver can switch between to best meet
their needs. Switching between modes is easy but can only be done when you
first connect the battery pack to the cap. After connecting the battery pack to
the cap, you have 10 seconds to momentarily press the “A” or “B” buttons 4
times to enter into “change mode”.When in “change mode” the LED on
buttons “A” and “B” will be red.The battery level LEDs will display which mode
you are in and if SBS™ Saver is turned on.The position of the green LED lets
you know which mode you are in and the red LED on the right lets you know
if SBS™ Saver is turned on. Momentarily pressing the “A” button will allow you
to switch between the 3 modes. Momentarily pressing button “B” is to turn
on/off SBS™ Saver. Please read below for details on SBS™ Saver.The controller
will automatically save and exit after 5 seconds without a button being pressed.
Mode 1
When in mode 1, button “A” will control the liner and button “B” will control
the socks and gloves. Both circuits have 4 power settings (off, 50%, 75%, 100%)
and cycle every time the button is momentarily pressed. Mode 1 is the default
mode and the SBS™ is already configured for this.
In mode 1 the circuit that is used for a light is always on and meant for lights
that have their own on and off switch on them.
Mode 2
When in mode 2, button “A” will control the liner and button “B” will control
the socks and gloves. Both circuits have 4 power settings (off, 50%, 75%, 100%)
and cycle every time the button is momentarily pressed.
In mode 2 the circuit that is used for a light is also controlled by the controller.
Pushing button “A” or “B” for a long press (3 seconds) will turn the light circuit
on and then return the display back to the liner socks/gloves power setting.
Pushing button “A” or “B” for a long press again will cycle the power off and
back on triggering your light to medium if your light supports it. Pushing button
“A” or “B” for a long press again will turn the light circuit off.
Mode 3
When in mode 3, button “A” will control the liner, socks and gloves. Button “B”
will control the light circuit. Button “A” has 4 power settings (off, 50%, 75%,
100%) and cycle every time the button is momentarily pressed. Button “B” has
3 settings (On, Medium** Off). In this mode the liner, socks and gloves will
always be at the same power setting.
** Please check online at http://www.dui-online.com/heat/Lights.html for compatible
lights and SBS™ configuration.
Battery Level LED’s
Battery Level LED’s
Battery Level LED’s
