PRE-DIVE CHECK & INSPECTION
Perform this BlueHeat™ System Pre-Dive Check and Inspection prior to
dressing and diving:
1. Using the Controller, check that the Smart Battery Pack is plugged in and
fully charged.
2. Check that button A and B are off (LED indicator should not be lit)
3. Connect the SBS™ to the valve port installed on your suit
4. Connect the liner to the matching liner connector on the inside of your
suit
5. If using the accessory gloves and socks, connect the accessory wiring
harness to the matching connector on the inside of your suit
6. Connect the gloves and socks to the harness in your liner
7.Turn on button A checking that the liner warms.Turn on button B
checking that the gloves and socks warm
8. If using an accessory light, check that it is working properly
9. Check that the lid is securely closed on the SBS™ canister.
!!WARNING!!
Failure to perform the Pre-Dive Check & Inspection
could result in damage to the System or failure to
operate. Always perform the Pre-Dive Check &
Inspection prior to every dive.
!!!CAUTION!!!
Do not leave the liner, gloves or socks on unless it is
being worn. Leaving the liner or accessory gloves and
socks turned on without wearing them for an extended
period of time could damage the System.
22
BLUEHEAT™ SYSTEM__________
UNCONTROLLED IF PRINTED
QSP-711-101