3.Take the left arm connector (shorter cable) and slide it into the LEFT
pocket zipper and out the small thread hole in the LEFT arm pit.Then
slide the connector into the sleeve tunnel (under arm) and down the arm.
4.Thread the left leg connector into the LEFT pocket and down the tunnel
on the left side of the suit. Slide the connector all the way to the bottom
so that the connector pops out.
5. Repeat steps 3 & 4 for the right side of the Liner.
6. Insert the main power connector into the RIGHT pocket and pull it
through the open media port.When the harness is adjusted correctly
there should be 10” to 18” of cable coming out depending on your size.
DIVE PREPARATION
1. Install the SBS™ canister on your diving equipment so that the controller
cable and suit cable will not restrict any motion.
2. Check that the valve port is installed correctly.
21
BLUEHEAT™ SYSTEM__________
UNCONTROLLED IF PRINTED
QSP-711-101
FIG. 15
FIG. 14
