14
BLUEHEAT™ SYSTEM__________
UNCONTROLLED IF PRINTED
QSP-711-101
SBS™ CONTROLLER
The SBS™ Controller provides the diver with control at their fingertips.You
can control zone A and B independently. Zone A is for the liner. Zone B is for
the accessory gloves and socks.The SBS™ Controller will also display your
battery packs capacity.The SBS™ Controller has the ability to control selected
light heads when plugged into the SBS™ canister. Please check online at
http://www.dui-online.com/heat/Lights.html for compatible lights and SBS™
configuration.
Installing the SBS™ Controller onto the SBS™ Cap:
1. Unscrew and remove the waterproof covers from the controller’s
connector and the SBS™ cap. Make sure to save the covers.They should
be used anytime the controller is removed from the SBS™ cap.
2. Check the O-rings on the SBS™ Controller for any damage. Replace as
needed. Match the pins on the Controller with the SBS™ cap and press
the connectors together then thread the locking ring until snug.This
connection should not be broken in the water. It will cause the housing to
leak.This connector is a dry connector only.
!!WARNING!!
All changing of attachments or caps must be done in a
dry environment. Failure to do so will result in the
flooding of the SBS™ battery housing.
Your SBS™ Controller can be attached to the diver in
multiple ways (See FIG. 6)
1. Attach a snap hook at the end (as indicated)
2. Attach to a retractor
3. Install wrist bungees to the four mounting holes provided (as indicated)
FIG. 5
