17
Section 10: Programming Descriptions (Advanced)
[001] Module IP
(Static IP address for the T-Link TL250/300 module)
Default:
192.168.000.099
Unique IP address for the module. The network administrator will provide this information. To
enable DHCP program the address as 000.000.000.000.
[002] Subnet Mask
Default
: 255.255.0.0
Must equal the subnet mask for the local subnet. For any single subnet, there is only one valid
subnet mask; all nodes on the same subnet will use the same subnet mask. The network adminis-
trator will provide this information.
NOTE: If DHCP is enabled then this section will be ignored.
[003] T-Link Account Code
Default:
0000FFFFFF
The account number is used by the central station to distinguish between transmitters. There is
one account number programmable for the TL250/TL300. This account number is only used
when transmitting signals from inputs or internal troubles. Signals received on the PC-Link
will use the control panel account number.
NOTE: Account codes 0000FFFFFF, FFFFFFFFFF and 0000000000 are not valid accounts. Refer to sec-
tion 5.3 T-Link DVACS Programming.
[004]-[005] Encryption Password
(32 Hex characters max.)
Default:
None
Once programmed the T-Link TL250/TL300 will use this data to encrypt and decrypt all
receiver and DLS messages. The user can program a value from 1-8 bytes long in each section.
To disable the encryption, program both sections with zeros. If the encryption key does not
match the central station key, then the communication will FTC.
NOTE: For UL/ULC Installations, an encryption key is required.
NOTE: E-mail messages are not encrypted.
[006] T-Link Installer Code
This code (Default 5555) is required when using the T-Link Console to remotely or locally
program the T-Link.
[007] Receiver #1 IP
(Static IP address for the receiver)
Default:
000 000 000 000
Program the IP address of the central station receiver.
[008] T-Link Gateway
Default
: 000.000.000.000
This is the IP address of the local gateway the TL250/TL300 can use to connect with the receiver
(WAN network). The IP address of the gateway must also be a valid IP address for the local sub-
net.
NOTE: If DHCP is enabled then this section will be ignored.
NOTE: The port numbers in the following sections are stored as hexadecimal data.
[009] Receiver #1 T-Link Source Port Number
Default:
3060 (0BF4
Hex
)
[010] Receiver #1 T-Link Destination Port Number
Default:
3061 (0BF5
Hex
)
[011] Receiver #2 IP
(Static IP address for the second receiver)
Default
: 000.000.000.000
Program the IP address of the second receiver.
[012] Receiver #2 Gateway
Default
: 000 000 000 000
This is the IP address of the local gateway the T-Link TL250/TL300 can use to connect with
the 2nd receiver (WAN network). The IP address of the gateway must also be a valid IP
address for the local subnet.
Summary of Contents for T-LINK TL250
Page 43: ......
