Copyright 2010 Baker Hughes Company.
English–PACE Indicators Instruction Manual | 41
Supervisor Setup
To configure the RS
-
232 connection:
1. Navigate to the supervisor communications configuration. Refer to Section
“Navigating to Communications Menu,” on page
2. On the COMMUNICATIONS screen, select RS232.
3. On the RS232 PARAMETERS screen, use the Up and Down arrows to highlight and edit the
desired parameter.
6.6.2.4 USB
Located on the rear panel an external USB ‘B’ connection has the following configuration:
Communications mode is selected for serial communications using the SCPI protocol.
Mass storage device is selected to mount an external USB ‘A’ connected mass storage device or
the internal memory SD card, from a PC connected to the USB ‘B’ port. When connecting a mass
storage device into the USB ‘A’ connector, the internal memory SD card becomes unaccessible.
Note:
When upgrading software, make sure that the USB ‘B’ connection is disconnected.
To configure the USB connection:
1. Navigate to the supervisor communications configuration. Refer to Section
“Navigating to Communications Menu,” on page
2. On the COMMUNICATIONS screen, select USB.
Table
6
-
3: USB ‘B’ Configuration Options
Item
Description
Communications Mode
Mass Storage Device or Communications
Protocols
SCPI
Terminator
CR or LF or CR/LF
Summary of Contents for PACE1000
