15
English
A p o l l o
80 -
i n s t r u c t i o n
f o r
i n s tA l l At i o n
➠
First place log A as indicated in
Fig. 4a en 4b
.
➠
Place log A up to E over the burners (see
Fig.
6b up to 6j
);
Caution
- Make sure log A is lying correctly in relation to the ridge, see the arrow.
➠
Next, you should place log B;
Caution
Make sure log B is lying correctly in relation to the ridges.
➠
Proceed with logs C, D and E.
Caution
- The logs should be placed exactly as indicated in
Fig. 6j
;
- The logs should not completely cover the burner deck, because:
- the main burner will not ignite properly; which could result in unsafe situations;
- the appliance will become fi lthy more quickly, as a result of soot;
- the fl ame image may be aff ected.
Thelogsetconsistsofvermiculite(see
Photo 2
),chippings(see
Photo 3
)andafewlogs.
➠
Fill the burner tray with the vermiculite, spreading it out evenly.
!N.B.
- You can alter the fl ame eff ect by moving the vermiculite but;
- the burner cap must remain covered by vermiculite to help preserve the useful life of the burner.
➠
Fill the tray surrounding the burner with chippings; spreading them out evenly;
➠
Identify the logs A - D using
Photo 4
for reference.
!Tip
The burn marks on the logs will help you identify them.
➠
Place block A around the (main) burner. This can only be done in one way (see
Photo 5
);
➠
Install block B, C and D (see
Photo 6, 7 and 8
).
6.10 Glass window
Oncethelogshavebeenarrangedtheglasswindowcanbefittedasdescribedbelow.
6.10.1 Removing the glass window
Removetheglassframeinaccordancewiththefollowinginstructions(see
Photos 7 to 12
):
➠
Remove the vertical decorative strips on the left and right of the glass frame by pushing the lip at the top of each strip
up, tilting the top of the strip parallel with the glass frame, and then removing the strip.
➠
Remove the horizontal decorative strip by gripping it with 2 hands in the slot and lifting it out.
➠
Unscrew the 4 self-tapping screws in the bottom strip using the socket spanner supplied with the appliance.
➠
Loosen the 3 self-tapping screws in the fastening strips on both sides 2 turns.
!N.B.
Do not remove the self-tapping screws: leave them in place in the fastening strips.
➠
Push the 2 top wedges (left and right) down as far as possible.
➠
Push the 2 bottom wedges upwards as far as possible.
➠
Press the two fastening strips outwards with your hands as far as possible to avoid damage to the sealing cord.
➠
Take hold of the top and bottom handgrips and lift the glass frame.
➠
Pull on the bottom handgrip to tilt the glass frame in its mounting towards you and, at the same time, pull the top of
the glass frame towards you as far as possible.
Photo 11
Photo 12
UK
