16
English
A
p o l l o
80 -
i n s t r u c t i o n
f o r
i n s tA l l At i o n
!N.B.
- Make sure you hold the upper handgrip firmly. If you let go of the handgrip then the glass frame could fall inwards
and cause severe damage to both the glass and the appliance;
- Make sure that you lift the glass frame out of its mounting as straight as possible to avoid damage to the paintwork
and the sealing cord.
➠
Gently allow the glass frame to drop at an angle until it can be removed entirely from the mounting.
6.10.2 Fitting the glass window
Theglassframeisfittedbyusingtheaboveprocedure,inreverseorder.
!N.B.
- Avoid/remove fingerprints on the glass, since otherwise they will burn into the surface;
- The self-tapping screws must not be over-tightened, since otherwise they could break or strip the thread:
tight=tight;
- Replace the fastening strip if the sealing cord has come loose.
Payattentiontothefollowingwhenfittingtheglassframe:
➠
Begin by checking that the two fastening strips are pressed outwards as far as possible to avoid damage to the sealing
cord.
➠
Fit the glass frame.
➠
Check that the hook at the top of the glass frame is in position in the seating / U-shaped strip.
!Tip
Pull on the upper handgrip to move the glass frame towards you: if it does not move, then it has been fitted correctly.
!N.B.
Fix the glass frame’s bottom strip in place with the 4 self-tapping screws.
➠
Push both bottom wedges downwards.
➠
Push the top wedges upwards until the sealing cord of both fastening strips press against the glass.
➠
Tighten each wedge’s self-tapping screw.
!N.B.
Press on the wedge with your hand to hold it in place while you tighten the screws.
➠
Tighten the middle self-tapping screw in each fastening strip.
➠
Fit the horizontal decorative strips.
➠
Fit the vertical decorative strips.
7. Wireless remote control
SeeChapter4oftheUserManual,‘RemoteControl’,fordetailsofhowtooperatethesystem.
Theremotesystemconsistsofaremotecontrolsystemandareceiver.
Theprocedureforconnectingthereceiverhasbeendescribedbelow;theworkingoftheremotecontrolsystemhas
beenexplainedindetailinChapter4,4.2oftheUserManual4,4.2
7.1 Receiver
Thereceivermustbeconnectedtotheappliancebeforethebatteriesareinserted.
Dothisasfollows(see
Photo. 13
):
➠
Slide the brown plug off the lead at the back on the PCB of the receiver;
➠
Connect the white plug to the gas control block.
!Tip
the plugs are different sizes and correspond with the connectors.
➠
Connect the thermocouple 2 wires to the receiver (see
Photo 13
, arrows B).
!Tip
- the size of the eye corresponds with the size of the screw;
- the colour of the eye and screw also correspond.
➠
Connect the black wire with the white plug of thermocouple 2 to the receiver (see
Photo 13
, arrow E).
Caution
Make sure that the wires of thermocouple 2 cannot come into contact with hot parts.
➠
Connect the ignition wire to the receiver (see
Photo 13
, arrow A);
➠
Connect the power supply:
a) For batteries see section 7.1.1 below;
b) For an adapter:
- connect the adapter to the receiver (see
Photo 13
, arrow C);
- plug the adapter into the wall socket.
UK
