4
English
A
p o l l o
80 -
i n s t r u c t i o n
f o r
i n s tA l l At i o n
➠
test the gastightness of all connections before use;
➠
use heat-resistant electrical connection materials;
➠
install the electrical connections away from the appliance;
➠
replace torn or broken panes;
➠
avoid blocking the explosion hatches;
➠
ensure the explosion hatches on top of the heater are right on their seats, before you close the chimney breast;
➠
do not ignite the appliance until installation has been completed.
4. Instructions
Toensuretheapplianceworkscorrectlyandsafely,alwaystakethefollowingpointsintoconsiderationduringinstallation:
➠
place the control box supplied as low as possible;
➠
ensure the ignition wire does not lie across the receiver;
➠
ensure the ignition wire does not touch or cross the aerial;
➠
to avoid weakening the spark ensure the ignition wire does not touch anything metal;
➠
if the appliance is to be built in flush with the wall, finish the edges neatly;
➠
do not plaster over the flanges;
➠
avoid damaging the glass when removing/fitting the window pane;
➠
to prevent dirt burning into the glass, make sure it is clean before use.
➠
make sure that the wires of thermocouple 2 cannot come into contact with hot parts.
5.
Unpacking
Pleasetakethefollowingpointsintoconsiderationwhenunpackingtheappliance:
➠
Check the appliance for transit damage;
➠
Contact DRU Service if necessary.
Oncethepackagingmaterialhasbeenremoved,youshouldhavethefollowingcomponents:
- Socket spanner: Youwillfindthisinthespacebetweentheassemblyframeandthecombustionchamber;
- Trimmings: Theseareinthesamespace.
Onceyouhaveremovedtheglasspaneyoucanremovetheboxofcomponentsfromthecombustionchamber.
!N.B.
Be careful not to damage the glass when removing/fitting the window pane.
➠
Remove the window as described in paragraph 6.10.1;
➠
Take the box of components out of the combustion chamber.
Annex1/Table4specifiesthecomponentsyoushouldhaveonceeverythinghasbeenunpacked.
➠
Contact DRU Service if after unpacking the appliance you do not have all the components;
➠
Dispose of the packaging in an appropriate manner.
6. Installation
Pleasereadthemanualcarefullytoensurethatonceinstalledtheappliancewillworkcorrectlyandsafely.
!N.B.
Install the appliance in the order described in this chapter.
6.1 Regulations
- Observethecurrentapplicable(installation)regulations;
- Observetheregulations/instructionslaiddowninthismanual.
6.2 Gas type
Thetypeplatespecifiesthetypeofgas,gaspressure,andthecountrythisapplianceisintendedfor.Thetypeplate
isonachainandthatiswhereitshouldstay.
N.B.
Check that the appliance is suitable for the local gas type and pressure.
6.3 Gas connection
Thegasconnectionshouldhaveagastaplocatedneartheappliance.
N.B.
Prevent any dirt getting into the gas pipes or connections.
Thefollowingrequirementsapplyforthegasconnection:
➠
the size of the gas pipe should be such that no pressure loss can occur;
➠
the gas tap must be CE marked;
➠
the gas tap should be accessible at all times;
➠
Do not twist the gas tap when connecting the gas pipe.
UK
