10
English
A
p o l l o
80 -
i n s t r u c t i o n
f o r
i n s tA l l At i o n
➠
Mount the gas control block on the brackets (2) on the inner frame;
➠
Reconnect the hoses to the gas control block.
N.B.
- Avoid kinks in the hoses;
- Tighten the fl exible hose and aluminium pipe making sure they are gastight;
- Screw the thermocouple 1 on by hand fi rst and then;
- then tighten it a quarter turn using a suitable spanner.
➠
Connect the thermocouple1 wiring to the gas control block if necessary; see
Photo 1
;
➠
Blow through the gas pipe if necessary;
➠
Connect the gas pipe to the gas tap;
➠
Bleed off the air in the gas pipe;
➠
Fit the receiver (3); see section 7.1 for connections;
➠
Fit the type plate (6);
➠
Fit the outer frame with door (4) to the inner frame using the two self-tapping screws (5).
!Tip
You can position the outer frame in such a way that the door opens to either the left or right.
6.8 Adjusting the appliance
Theappliancehastobesetinsuchawaythatitworkscorrectlyincombinationwiththedischargesystem.
Forthatpurpose,abaffleisplacedand/ortheairinletguidesareremoved.Theconditionsforusingawallductare
describedinsection6.5.2.1,andforusingaroofductinsection6.5.3.1.
Caution
For Belgium, the condition applies that the primary aeration of the burners has to be changed, if the appliance is used
with gas G25 instead of G20; see section 6.8.3.
6.8.1 Baffl e (R)
Thebaffle(R)issuppliedseparately.
Itismountedasfollows:
➠
Place the baffl e. (see
Fig. 6a and 6b
)
➠
Use the template supplied to set the distance of the restriction (see
Fig. 7
) as follows:
- A distance of 30 mm, means that the baffl e will be fully closed;
- A distance of 37 mm is set by means of the template;
- A distance of 41 mm is set by means of the template;
- A distance of 44 mm is set by means of the template;
- A distance of 60 mm is set by means of the template;
➠
Fix the baffl e by using the socket cap screw (U).
6.8.2 Air inlet guides (L)
Theairinletguides(L)arelocatedatthebottom(side)ofthetrayaroundtheburner.
Removethemasfollows;see
Fig. 8
:
➠
Remove the tray surrounding the burner (M);
➠
Unscrew and remove the self-tapping screws (N);
➠
Remove the air inlet guides;
➠
Replace the tray round the burner.
38c-1078
1
2
4
5
3
6
Fig. 5
Damper
socket-head screw
Fig. 6a
60
44
41
37
Fig. 7
38c-1269
Damper
Fig. 6b
UK
