Installation and Set Up
SVI II AP Maintenance
15
Display Cover Removal and Installation
The cover with display (shown in Figure 8 below) is an option for the SVI
II AP. If you have an SVI II AP with a solid cover and would like to
upgrade to a display cover, follow the instructions below for removal
and installation.
Removing the SVI II AP Display Cover
To remove the SVI II AP Display cover:
1.
Using a 5 mm Hex key unscrew the four screws around
the perimeter of the SVI II AP cover.
2.
Lift the cover off the positioner.
Pneumatic
Cover
Cover
Display
Figure 8
SVI II AP Pneumatic and Display Covers
Installing the SVI II AP Display Cover
Note:
After replacing the SVI II AP Display Cover you must power up
the unit (see “Powering Up the SVI II AP” on page 23 of this
guide).
The replacement Display Cover is shipped with a lanyard to prevent the
cable (that connects from the display to the Terminal Board) from
breaking. The lanyard must be inserted under the screw in the lower
left corner, that attaches the terminal board to the SVI II AP housing.
To Install the cover:
1.
Install the lanyard and tighten the screw to 5 in/lb.
Summary of Contents for Masoneilan SVI II AP-2
Page 1: ......
Page 8: ...Masoneilan Dresser SVI II AP Quick Start Guide vi ...
