Dresser Masoneilan SVI II AP-2, Quick Start Manual

Page: 10 / 57

SVI II AP Cover
SVI II AP Assembled
Electronics
Module
Pneumatic Train and
Cover (I/P Module, Relay)
Manifold
Relay
I/P
Masoneilan Dresser SVI II AP Quick Start Guide
2
Figure 2 SVI II AP Components
Using the
Quick Start
Guide
The SVI II AP Quick Start Guide is intended to help an experienced
Field Engineer install, setup, and calibrate an SVI II AP in the most
efficient manner possible. This document provides basic installation
and setup instructions and is not intended to replace the in-depth
information contained in the SVI II AP Instruction Manual EW2002-AP.
If you experience problems that are not documented in this guide refer
to the Masoneilan SVI II AP Instruction Manual EW2002-AP, call your
local Masoneilan representative, or go to www.masoneilan.com. Sales
offices are listed on the last page of this document
The steps necessary to complete the SVI II AP installation and software
setup are outlined in Table 1 below.
Table 1 SVI II AP Installation Steps
Step No. Procedure Reference
1 Attach mounting bracket to the
actuator. See page 3 for rotary valve and
reciprocating valve instructions.
2 Install the SVI II AP magnetic
assembly (rotary valves only). See page 3 for instructions.
3 Assemble the SVI II AP on the
bracket that is mounted to the valve
actuator. See page 3 for rotary valve and
reciprocating valve instructions.