6. Select channel options you wish to allow student to manipulate by selecting
”Master” to retain control and “Slave” to give control to the student. Select this
for each of the controls.
The Master Controller can now turn over
control to the student once the Slave
Controller has been set up and the Trainer
button on the Master Controller is
depressed and held.
Slave Controller Setup
Ensure no other Draganflyer X8 helicopter is turned on.
1. Turn on Slave Controller
2. Using Touch Screen tap “Config” once
3. Select “Trainer Setup by tapping “Trainer Setup” once
4. Trainer Mode button should display “Off”, select ”Slave”
5. Select “Acquire”. The controllers will now communicate and acknowledge when
they find each other by indicating on the touch screen the status. For the Slave
Controller a message box will show “Transmitter correctly paired with Master”
After pressing “Done” the Slave Controller will show” Master Found”. On the
Master Controller it will show “Slave Present”
In addition to the Touch Screen indication of status an audible set of tones will
indicate a change of status. A rising tone indicates control to the Slave. A
lowering of tones indicates control to the Master.
Draganflyer X8 – Users Manual
74
07/13/11 Ver 11-01 e
