CONTACT US AT
www.DRpower.com
15
Cleaning the Air Filter
Never twist the air filter element when cleaning, always press.
Tool & Supplies Recommended:
Flat Head Screw Driver
Liquid Detergent and Warm Water
Clean Cloth
Lightweight motor oil
1.
Before removing the Air Filter Cover, move the Choke Lever to the CHOKE position (
Figure 7
).
2.
To remove the Air Filter Cover, squeeze the Latch Tabs on both sides of the Cover (
Figure 8
).
3.
Once you release the Latch Tabs, remove the Air Filter Cover by rotating the Cover away from the Engine (
Figure 9
).
4.
Remove the foam Air Filter Element (
Figure 10
) and replace with a new oiled Element, or clean the original foam Element
by
washing it in liquid detergent and warm water to remove dirt and debris. Press the Filter Element when washing; DO
NOT TWIST.
5.
Rinse the Filter Element in warm water to remove the soap and dirt.
6.
Dry the Filter Element by wrapping it in a clean cloth and pressing the Element until dry.
7.
Apply lightweight motor oil or a thin base machine oil to the entire Element and remove the excess oil.
8.
Wipe out any dirt from inside the Air Filter Housing and reinstall the foam Element, pressing it evenly in place to fully seat
it in its sealed position (
Figure 11
).
9.
Replace the Air Filter Cover so that it fully snaps into place and secured by the Latch Tabs. Check that the Cover is
securely attached by pulling slightly on the Cover. Reattach the Spark Plug wire.
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Summary of Contents for PILOT 2
Page 21: ...CONTACT US AT www DRpower com 21 Schematic Diagram Handlebar Assembly...
Page 23: ...CONTACT US AT www DRpower com 23 Schematic Diagram Transmission Assembly...
Page 25: ...CONTACT US AT www DRpower com 25 Schematic Diagram Engine Assembly...
