CONTACT US AT
www.DRpower.com
13
Adjusting the Wheels and Drag Stake
Adjusting the Wheels
You can adjust the Wheels on the DR PILOT 2 Cycle
Tiller/Cultivator to one (1) of three (3) positions (
Figure 5
).
Use the lowest Wheel position for transporting the machine
across a smooth level surface while the Engine is not running.
Use the two (2) higher positions for tilling in soil and to help
stabilize the unit when tilling at different depths.
1.
Pull the Locking Sleeve toward the Wheel against the
Spring until it releases from one of the three (3) holes in
the Vertical Guide.
2.
Slide the Wheel Set up or down to the desired position,
and then release the Locking Sleeve until it locks into one
(1) of the three (3) Holes in the Vertical Guide.
Adjusting the Drag Stake
The Drag Stake (
Figure 6
) is used to help regulate tilling depth
and control the machine from lurching forward during
operation. Set the Drag Stake in its lowest position of three (3)
to provide the greatest resistance to forward motion allowing
for deeper tilling.
1.
Pull the Lock Pin out of the Drag Stake Mounting Hole.
2.
Position the Drag Stake to the desired depth and reinsert
the Lock Pin.
Figure 5
Figure 6
Highest
Middle
Lowest
Locking Sleeve
Spring
Vertical Guide
Drag Stake
Lock Pin
Summary of Contents for PILOT 2
Page 21: ...CONTACT US AT www DRpower com 21 Schematic Diagram Handlebar Assembly...
Page 23: ...CONTACT US AT www DRpower com 23 Schematic Diagram Transmission Assembly...
Page 25: ...CONTACT US AT www DRpower com 25 Schematic Diagram Engine Assembly...
